Simaudio Preamplifier and D/A converter - Manual (Page 19)

MOON Stargate Processor
Basic Function Remote Control Operation
The MOON Stargate uses a second remote control, the ‘WRM’
basic function (figure 10). The main purpose of the ‘WRM’ is for
everyday remote operation once the Stargate has been properly
calibrated. This remote uses two AAA batteries (included). To
install them, use the supplied Allen key to remove the three screws
located on the back plate; insert the batteries in the correct
direction and then screw the back plate back into place.
The
STANDBY button will switch the Stargate from either ‘Stand by’
to ‘On’ mode or vice versa.
The INPUT + and INPUT – buttons perform the same function as
the buttons located on the Stargate’s front panel (refer to page
12), allowing you to sequentially cascade through each of the
possible 11 source inputs in the following order:
DVD, TUNER, 7.1,
CD, TAPE, AUX, SAT, TV, LD, VCR1 and VCR2.
The VOL + and VOL – buttons also perform the same function as
the buttons located on the front panel: increasing or decreasing the
output volume
The SURR button places the processor into “Surround” mode
exactly the same way as the same button located on the unit’s
front panel.
The STEREO button places the processor/preamplifier into “Stereo
mode” (2-channel audio for front left & right speakers only).
Figure 10: WRM Remote Control
____________________________________________________________________________________
Basic Function Remote Control Operation 19