Vcr and cable box, D 35 – Sony GRAND WEGA KDF-E50A10 User Manual
Page 35
Connecting the TV
35
Conn
ectin
g the
TV
KDF-E42A10/KDF-E50A10
2-597-544-13(1)
D:\WINNT\Profiles\noriko\Desktop\2-597-544-13(1)
TROY_EN\2597544131\01US04INS.fm
masterpage:3 columns Right
VCR and Cable Box
Use this hookup if:
❑
Your cable TV company scrambles some channels, but not all of them
(pay channels vs. regular cable channels) and you need to use a cable
box.
With this connection you can:
❑
Use the TV’s remote control to change channels on your cable box
when the signal is scrambled. To program your Sony remote control to
operate your cable box, see “Programming the Remote Control” on
page 47.
❑
Use the TV’s remote control to change channels on your TV when the
signal is not scrambled. Your TV’s tuner provides a better picture
quality than the output of your cable box.
Disconnect all power sources before making any connections.
1
Connect the CATV cable to the single (input) jack of the splitter.
2
Use a coaxial cable to connect one of the output jack of the splitter to
the TV’s CABLE jack.
3
Use a coaxial cable to connect the splitter’s other output jack to the
cable box’s input jack.
4
Use a coaxial cable to connect the cable box’s output jack to the VCR’s
RF input jack.
5
Use an A/V cable to connect the cable box’s A/V output jacks to the
TV’s A/V input jacks.
6
Use an A/V and S VIDEO cables to connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.
7
Run Initial Setup, as described in “Setting Up the Channel List” on page
32.
Before connecting a cable
box, see “Using
✍
If your VCR is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
✍
To view scrambled channels, tune the TV to the channel the cable
box is set to (usually channel 3 or 4) and then use the cable box to
switch channels.
(Continued)