Indicators, Projection lamp, Indicators projection lamp – Sony GRAND WEGA KDF-E50A10 User Manual
Page 12
Introducing the TV
12
KDF-E42A10/KDF-E50A10
2-597-544-13(1)
D:\WINNT\Profiles\noriko\Desktop\2-597-544-13(1)
TROY_EN\2597544131\01US03WEL.fm
masterpage:3 columns Right
Indicators
The indicators show the current status of your TV. If there is a change in the
condition or a problem with the TV, the indicators will flash or light up in
the manner described below to let you know that it requires your attention.
Projection Lamp
Your TV uses a projection lamp as its light source. As with any lamp, it has
lifespan and needs to be replaced when the Lamp indicator flashes or the
screen becomes darker. Note the following:
❑
After turning on your TV, it may take a while (1 minute or less) before
the picture appears.
❑
When the projection lamp wears out, the screen goes dark. Replace the
lamp with a new Sony XL-2400 replacement lamp (not supplied).
Indicator
Flashing because...
POWER/
STANDBY flashing
green : The lamp for the light source is preparing to turn
on. When it is ready, it turns on.
red : The lamp door or the lamp is not securely attached.
The red indicator will continue to flash in intervals of three
blinks at a time until the lamp door or the lamp is placed
correctly. When the lamp door or the lamp is securely
attached, the TV will turn on with green indicator.
LAMP indicator
flashes
The projection lamp has burned out. Replace it with new
one (see page 86).
TIMER indicator is
lit
When one of the timers is set, the indicator will remain lit
(will not flash) even when the TV is turned off.
PUSH OPEN
POWER/STANDBY
POWER
TIMER
LAMP
Indicators
Screen
How to replace the lamp,
✍
The light emitted from the lamp is quite bright when your TV is in
use. To avoid eye discomfort or injury, do not look into the light
housing when the power is on.