Smart Technologies Interactive Whiteboard System 480i5 - Manual (Page 68)

Powerstate controls
These commands place the projector in and out of Standby mode and request the projector’s current
powerstate. The projector’s powerstate determines whether certain commands are available at that
time. These settings are available even when the projector is in Standby mode.
Command Response
on powerstate=[field]
off powerstate=[field]
off now powerstate=[field]
get powerstate powerstate=[field]
The following table describes the powerstate commands:
Command Description
on Turns on the projector.
off Starts the shutdown process. A dialog box appears with the
message, “Press Power Button to Turn off Projector.” You must send
a second Off command within 10 seconds to put the projector into
Standby mode.
off now Shuts down the projector immediately. You can’t delay or cancel this
command.
get powerstate Indicates the projector’s current powerstate.
The following table describes the powerstate fields:
Field Description
Powering The projector is turning on.
On The projector is on.
Cooling The projector is cooling.
Confirm off Confirm off is a non-selectable powerstate that is returned during
stage one of the two-button off sequence.
Idle The projector is off but still receiving power (Standby mode).
Source selection controls
These commands switch input sources. The source type determines which commands can be
accepted.
Command Response Available when in Standby
mode
get input input=[field] Yes
set input [field] input=[field] No
A P P E N D I X A
Remotely managing your interactive whiteboard system
58