Smart Technologies Interactive Whiteboard System 480i5 - Manual (Page 22)

Adjusting projector settings
The remote control’s Menu button enables you to access the on-screen display to adjust the projector
settings.
I
I M P O R T A N T
Keep your remote control in a safe place because you are unable to access projector menu options
using any other means.
Setting Use Notes
Image Adjustment menu
Display Mode Indicates the projector’s display output
(SMART Presentation, Bright
Room, Dark Room, sRGB and
User). The default is SMART Presentation.
Brightness Adjusts projector brightness from 0 to
100. The default is 50.
Contrast Adjusts the difference between the
lightest and darkest parts
of the image from 0 to 100. The default is 50.
Frequency Adjusts the display data frequency of
the projected image from -5 to 5 to
match the frequency of your
computer’s graphics card. The default is 0.
This setting applies to VGA inputs
only.
Tracking Synchronizes your projector’s display
timing with your computer’s graphics
card from 0 to 63. This setting applies to VGA inputs
only.
H-position Moves the projected image’s horizontal
position left or right from 0 to 100. Don’t adjust this setting unless you’re
advised to by a certified SMART
Support specialist
(
smarttech.com/contactsupport ).
You can apply this setting only after
you make all boom adjustments.
This setting applies to VGA inputs
only.
V-position Moves the projected image’s vertical
position up or down from -5 to 5. Don’t adjust this setting unless you’re
advised to by a certified SMART
Support specialist
(
smarttech.com/contactsupport ).
You can apply this setting only after
you make all boom adjustments.
This setting applies to VGA inputs
only.
C H A P T E R 3
Using your interactive whiteboard system
12