Smart Technologies Interactive Whiteboard System 480i5 User Manual

Page 42

To put the new lamp module into the projector

1. Remove the new lamp module from its packaging.

2. Carefully place the lamp module into the projector using the handle on the top of the module.

Hold the lamp module vertically and guide it into its slot. Gently press the power end of the

lamp module against the projector to ensure the power plug makes contact with the projector’s

power receptacle.

N O T E

You should be able to place the lamp module into the projector easily without applying much

force.

3. Use the Phillips screwdriver to tighten the captive screws.

4. Carefully replace the lamp cover.

5. Connect the power cable to the wall outlet.

6. Press the Power

button once on the remote control to confirm that the projector is operating

and that the lamp module is correctly installed

7. Put the old lamp in a secure container, and handle it gently until you recycle it.

To finish the projector lamp installation

1. Turn on the projector.

2. Adjust the projector image if necessary (see Adjusting the image on page 19).

3. Access the service menu to reset the lamp hour counter (see Resetting the lamp timer on next

4. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see E-mail

C H A P T E R 5

Maintaining your interactive whiteboard system