SOYO Motherboard SY-6BA+ IV - Manual (Page 55)

Hardware Installation SY-6BA+ IV
51
2. Set the JP8 and JP9 to short if you use a FSB 66MHz CPU
3. Press and hold down the key while turning on the system
power. Keep holding down the key until you see the message
of the CPU type and frequency shown on the screen.
4. Press the key during the system diagnostic checks to enter the
Award BIOS Setup program.
5. Select [SOYO COMBO SETUP] and move the cursor to the [CPU
Frequency] field to set the proper working frequency.
6. Select [Save & Exit SETUP] and press to save the new
configuration to the CMOS memory, and continue the boot sequence.
Note: SOYO does not guarantee system stability if the user over
clocks the system. Any malfunctions due to over-clocking are not
covered by the warranty.
2-3.9 Power Off
There are two possible ways to turn off the system:
1. Use the Shutdown command in the Start Menu of Windows 95/98
to turn off your computer.
2. Press the mechanical power-button and hold down for over 4
seconds, to shutdown the computer. If you press the power-button for
less than 4 seconds, then your system will enter into Suspend Mode.
You are now ready to configure your system with the BIOS setup program.
Go to Chapter 3: BIOS SETUP