SOYO Motherboard SY-6BA+ IV - Manual (Page 53)

Hardware Installation SY-6BA+ IV
49
(c) AGP Clock
This option allows you to manually adjust the AGP host bus clock
frequency to a value determined as a fraction of the CPU host clock.
For example:
With a CPU front side bus of 100MHz,
[Auto] sets à
When [auto] is selected and the (FSB Frequency) is
less then 100MHz, it will be divided by [/ 1]. Otherwise it will
be divided by [/ 1.5].
[/ 1] sets à AGP Clock = 100MHz
[/ 1.5] sets à AGP Clock = 66.6MHz
AGP Clock options are:
o
Auto o
÷
1.0
o
÷
1.5
(d) Vcore Voltage Adjust
The CPU notifies the board of what core voltage it requires by its VID
outputs. The on-board voltage regulator uses the VID code to set the core
voltage. If the Vcore Voltage Adjust is set to normal, the Vcore will be
exactly what the VID code specifies. If an adjustment percentage is
selected the Vcore will be that percentage higher than the VID code
specifies. For instance the CPU VID code specifies 2.0V and the Vcore
Voltage adjust is set to +10.0% the actual CPU Voltage will be 2.2V. This
function should only be used if the CPU is running on FSB Frequencies
beyond the CPU specifications, note that SOYO does not guarantee
system stability if this item is not set to normal.
Don’t forget to raise the upper limit of the CPU Vcore monitoring voltage
in the Hardware Doctor

utility if Vcore is set to higher voltage than VID
specifies.
o
Normal
o
+ 2.5 %
o
+ 5.0 %
o
+ 7.5%
o
+10.0 %
Step 4.
Select [SAVE & EXIT SETUP]
Press to save the new configuration to the CMOS memory, and
continue the boot sequence.