Subaru A3100BE - Manual (Page 64)

1-40
Seat, seatbelt and SRS airbags
the seatback.
Each lower anchorage is located where
the seat cushion meets the seatback.
0
1. Slide the seat or seat pair to its rear-
most position.
2. Make the clearance between the seat
cushion and seatback a little wider to lo-
cate the two anchorages (bars) for the po-
sition where you want to install the child
restraint system.
3. While following the instructions sup-
plied by the child restraint system manu-
facturer, connect the lower hooks onto the
lower anchorages located at “
” marks
on the bottom of the seatback. When the
hooks are connected, make sure the adja-
cent seatbelts are not caught.
4. [If your child restraint system is of a
flexible attachment type (which uses teth-
er belts to connect the child restraint sys-
tem properly to the lower anchorages)]
While pushing the child restraint into the
seat cushion, pull both left and right lower
tether belts up to secure the child restraint
system firmly by taking up the slack in the
belt.
5. Connect the top tether hook to the teth-
er anchorage and firmly tighten the tether.
For information on how to set the top teth-
er, read the following “Top tether anchor-
ages”.
When you install a child restraint
system, follow the manufacturer’s
instructions supplied with it. After
installing the child restraint system,
check to ensure that it is held se-
curely in position. If it is not held
tight and secure, the danger of your
child suffering personal injury in the
event of an accident may be in-
creased.
100519
100520
100521