Registering your phone – Siemens Gigaset S45 User Manual

Page 6

First Steps

Gigaset S45 / en / A31008-M1754-R101-1-6Z19 / start_guide_time.fm / 02.09.2005

Attaching the belt clip

There are notches for attaching the belt

clip on the side of the handset at the same

height as the display.

Press the belt clip onto the back of the

handset so that the lugs on the belt clip

click into the notches.

Opening the battery cover

If fitted, remove the belt clip.

Slide your finger nail or a screw driver

down the notch to separate the belt

clip from the cover. Push the entire

cover upwards so that it unclicks.

Registering your phone

Before you can use your Gigaset S45 you

must register it to a base station. It can be

registered to a maximum of four base sta-

tions. The actual registration procedure

will depend on the type of base station.

Automatic registration Gigaset S45 to

Gigaset S450/S455

Important: The handset must not already

be registered to any base station.
Registering the handset to the Gigaset

S450 base station occurs automatically.

Place the handset in the base with its

display facing forward.

Registration takes around 1 minute. Dur-

ing this process,

Regstr.Procedure

appears

in the display and the name of the base

station flashes e.g.

Base 1

. When the

handset has registered, its screen displays

its internal number, e.g.

INT 2

for internal

number 2. The handset is assigned the

lowest available internal number (1-6). If

all internal numbers 1-6 have been

assigned, number 6 is overwritten, pro-

vided the handset with the internal

number 6 is in idle status.

Manual registration Gigaset S45

If the handset does not switch on auto-

matically when the batteries are fitted,

you must first charge the batteries.
You must activate manual registration of

the handset at both the handset and the

base station.
After it has registered, the handset returns

to idle status. The handset's internal

number is shown in the display e.g.

INT 1

If not, repeat the procedure.

Notes:

– Automatic registration is not possible when

the base station on which you wish to reg-

ister the handset is being used to make a

call.

– Each key press interrupts the automatic

registration.

– If automatic registration does not work,

you will have to register the handset manu-

ally.