Charging the battery – Siemens Gigaset 200 User Manual

Page 11

Getting started

s\C75 Aries\mx_us-en\LA\Aries_Startup.fm

Template:

X75, 140x105, Version 2.2;

VAR Languag

e: am; VAR issue date: 050718

left page (10)

of C75 Aries, w/o ptt, FUG, 143 mm, mx_us-en, A31008-H6970-A40-1-4A19

Charging the battery

The battery is not fully charged

when delivered. Plug charger cable

into the bottom of the phone, plug

power supply unit into a wall outlet

and charge for at least two hours.
As an alternative, the battery can be

charged via the USB port (see Acces-

sories, page 127).

Display during charging.

Charging time

A discharged battery is fully charged

after about 2 hours. Charging is only

possible within a temperature range

of +5 °C to 45 °C (41 °F to 113 °F). If

the temperature rises/falls 5 °C (9 °F)

above/below this range, the charge

symbol flashes a warning. The line

voltage specified on the power sup-

ply unit must not be exceeded.

Operating time

The operating time depends on the

conditions of use. Extreme tempera-

tures considerably reduce the

phone’s standby time. Avoid leaving

the phone in the sun or on a heater.

Call time: 100 to 330 minutes

Standby time: 60 to 300 hours

Charge icon not visible

If the battery is fully discharged, the

charge icon is not immediately visi-

ble when the power supply is

plugged in. It will appear after up to

two hours. In this case, the battery is

fully charged after 3 to 4 hours.
Only use the plug-in power supply

included in the delivery!

Display while in service

Charge level display during opera-

tion (empty–full):

A beep sounds when the battery is

nearly flat. The charge level of the

battery is only displayed correctly af-

ter an uninterrupted charging/dis-

charging cycle. You should therefore

not remove the battery unnecessarily

and where possible not finish the

charging process prematurely

Additional information
The power supply unit heats up when used

for long periods. This is normal and not

dangerous.
If the battery is removed for longer than

30 seconds, the clock must be reset.