Multi-handset configuration – Sanyo LNS-W10 User Manual
Page 22
22
This feature only works if you have 2 handsets registered to the base unit.
MULTI-HANDSET CONFIGURATION
1.
Press INT on the first handset.
2.
Press or to select the desired handset or choose “CALL ALL”.
3.
Press TALK to place the call. The selected handset will ring. If you select
“CALL ALL”, all other handsets registered to the base unit will ring. If the
selected handset is not available (off hook, on another call), “BUSY” shows.
4.
To accept the intercom call on the handset, press TALK.
5.
To exit intercom mode on the first handset, press TALK.
Note: During the first handset calls the other handsets, there may be an incoming call
in which the first handset will hear a call waiting tone and the other handset will return
to normal incoming call tone.
Intercom ring tone
You can change the ring tone for an intercom call to differentiate internal from
external calls. To change the ring tone please see the Handset Ring Tone Setting
section on page 12 for more information.
Call toggling
This feature only works if you have 2 handsets registered to the base unit. The
feature allows you to put an external call on hold while you place an intercom call to
another handset. Only the handset that initiates call toggling can place callers on hold
or end the call.
1.
Establish contact with an external party by either placing a call or answering an
incoming call.
2.
Press INT to put the external call on hold and enter intercom mode.
3.
Press the number (1-4) for the handset you wish to select, or use the or
keys to select the handset.
4.
Press TALK to place an intercom call to the selected handset. “H” shows on the
display to indicate the external call is on hold.
5.
Press INT key on the handset that initiates call toggling to place the intercom on
hold and return to the external call.
6.
Press TALK key on the selected handset to end the intercom call and return to
the external call.
Note: If the selected handset is not available, “BUSY” shows and then a callback is
generated. “CALL BACK” is displayed on the handset display. You can press TALK to
return to the caller.