JVC GET0635-003A - Manual (Page 61)

1
KD-R516/KD-R515
Installation/Connection Manual
ENGLISH /
1209DTSMDTJEIN
EN, CT
© 2009 Victor Company of Japan, Limited
GET0634-010A
[UT]
Bracket / * 2
Pocket /
Flat head screws (M5 × 8 mm) / M5 × 8 mm * 2
INSTALLATION /
When installing the unit without using the sleeve /
In-dash mounting /
• To prevent short circuits:
– Disconnect the battery’s negative terminal and make all electrical connections before installing the unit.
– Cover the terminals of the UNUSED leads with insulating tape.
• Be sure to ground this unit to the car’s chassis again after installation.
• Replace the fuse with one of the specified rating.
• Connect speakers with a maximum power of more than 50 W (impedance of 4 Ω to 8 Ω). Otherwise,
change the setting. (See page 15 of the INSTRUCTIONS.)
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
•
•
•
•
•
12 V DC, NEGATIVE ground /
To the car system / You need the installation kits which corresponds to your car. / Check the battery system in your car /
WARNINGS /
Removing the unit /
Release the rear section first... /
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
Heat sink
JVC
Do the required electrical connections.
Bend the appropriate tabs to hold the sleeve
firmly in place.
Install the unit at an angle of
less than 30˚.
* 1
* 1 When you stand the unit, be careful not to damage the fuse on the rear.
* 2 Not supplied for this unit.
* 1
* 2
Part list /
A Hard case /
(×1)
B Control panel / (×1)
C Sleeve / (×1)
D Trim plate / (×1)
E Power cord /
(×1)
F Handles / (×2)
Install_KD-R516_010A_1.indd 1 Install_KD-R516_010A_1.indd 1 11/30/09 9:13:10 AM 11/30/09 9:13:10 AM