JBL EVOi.net - Manual (Page 3)

EVOi.net
1
IMPORTANT SAFETY INFORMATION - READ THIS CAREFULLY
This equipment has been tested and found to comply with the following European and international standards for Electromag-
netic Compatibility and Electrical Safety:
Radiated Emmissions (EU): EN55022B (1992)
RF Immunity (EU): IEC801-3 (1994)
Electrostatic Discharge(EU): IEC801-2 (1984)
Fast Transients(EU): IEC801-4 (1988)
Electrical Safety (EU): EN60065 (1994)
Electrical Safety(USA): UL6500/ETL (1996)
Electrical Safety(CAN): CAN/CSA-E65/ETLc (1996)
Before using the apparatus read these instructions, follow all instructions, heed them and keep in a
safe place.
Clean only with a damp cloth. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s
instructions.
Do not defeat the safety purpose of the grounding type plug. A grounding plug has two blades and a third grounding prong. The
third prong is provided for your safety. When the provided plug does not fit into your outlet, consult an electrician for replace-
ment of the obsolete outlet.
Protect the power cord from being walked on or pinched particularly at plugs, convenience recepticals and the point where they
exit from the apparatus.
Only use attachments/accessories specified by the manufacturer.
Unplug this apparatus during lightning storms or when not in use for a long time.
WARNING – TO REDUCE THE RISK OF FIRE OR SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR
MOISTURE.
DO NOT REMOVE COVERS, NO USER SERVICABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
THIS EQUIPMENT MUST BE GROUNDED.
IT SHOULD NOT BE NECESSARY TO REMOVE ANY PROTECTIVE GROUND OR SIGNAL CABLE SHIELD
CONNECTIONS TO PREVENT GROUND LOOPS. ANY SUCH DISCONNECTIONS ARE OUTSIDE THE
RECOMMENDED PRACTICE OF JBL PROFESSIONAL AND WILL RENDER ANY EMC OR SAFETY
CERTIFICATION VOID.
For continued compliance with international EMC legislation ensure that all input and output cables are wired with the cable
screen connected to Pin 1 of the XLR connectors. The input XLR Pin 1 is connected to the chassis via a low value capacitor,
providing high immunity from ground loops while ensuring good EMC performance.
DO NOT EXPOSE
TO RAIN OR MOISTURE
CAUTION
RISK OF ELECTRONIC SHOCK
DO NOT OPEN
!
NE PAS EXPOSER A
LA PLUIE NI L'HUMIDITE
ATTENTION
RISQUE DE CHOC ELECTRIQUE
NE PAS ENLEVER