JBL EVOi.net - Manual (Page 27)

EVOi.net
25
A P P E N D I X
POWER UP OPERATION
There are two scenarios:
a) EVO Speakers have been changed/replaced or the
speakers hook up configuration is different.
b) EVOi.net has been changed/replaced.
Because of the difficulty in reliably determining which is
the appropriate scenario, the same procedure will be used in
both situations, and will allow the user to go back to the
alternative data set:
1. When powered up, the EVOi.net will download the
data from the speaker and compare the EVO loud-
speaker data with the EVOi.net stored data. If the data
in the EVO loudspeakers does not match the data in the
EVOi.net, the SPEAKER STATUS indicators will
signify power-up disagreement error. Audio will not be
allowed to pass at this time.
2. The EVOi.net will backup the data that came from the
speakers to preserve it.
3. The EVOi.net will upload the original stored data into
the speakers.
4. If the user is happy with this, any button press will
clear the error, and unmute the system
5. To swap the data with the backed-up original speaker
data, the press MAIN OUT SETUP 1&2, AUX OUT
3&4, and DELAY SETUP simultaneously to download
the backed up EVO system data back into the EVO
loudspeakers. This will back-up the original EVOi.net
data, which the user can swap back to if required.
6. As a last resort the user may press the square LIVE
AFC ON, EQ SELECT, and AEQ ON buttons
simultaneously and restore the EVOi.324 settings to
their original factory defaults.