Jensen MP6612i User Manual
Page 12
MP6612i
8
•
LEVEL
Turn the rotary encoder clockwise to increase or counter-clockwise to
decrease the Bass level from “-6” to “+6”. “0” represents a flat response.
•
Bass Center Frequency (C. FREQ)
Turn the rotary encoder clockwise to adjust the Bass Center Frequency
to 60, 80, 100 or 200Hz.
•
Bass Quality Factor (BASS-Q)
Turn the rotary encoder to select one of the following Bass Quality
Factor options: 1N, 2N, 2W, 1W. The following chart depicts the curve
characteristics for each step:
Mid-Range (MID)
To adjust Mid-Range options, press the MENU button (22) three times or
until “MID” appears in the display. Press the TUNE/TRACK >>| or |<<
buttons (19) to access the following Mid-Range settings:
•
LEVEL
Turn the rotary encoder clockwise to increase or counter-clockwise to
decrease the Mid-Range level from “-6” to “+6”. “0” represents a flat
response.
•
Mid-Range Center Frequency (C.FREQ)
Turn the rotary encoder to adjust the Mid-Range Center Frequency to
500Hz, 1KHz, 1.5KHz, or 2.5KHz.
•
Mid-Range Quality Factor (MID-Q)
Turn the rotary encoder to select one of the following Mid-Range
Quality Factor options: 1N, 2N, 2W, 1W. The following chart depicts the
curve characteristics for each step:
TREBLE
To adjust Treble options, press the MENU button (22) repeatedly until
“TREBLE” appears in the display. Press the TUNE/TRACK >>| or |<<
buttons (19) to access the following Treble settings:
•
LEVEL
Turn the rotary encoder clockwise to increase or counter-clockwise to
decrease the Treble level from “-6” to “+6”. “0” represents a flat
response.
•
Treble Center Frequency (C. FREQ)
Turn the rotary encoder clockwise to adjust the Treble Center
Frequency to 10KHz, 12.5KHz, 15KHz or 17.5KHz.
LOUD
When listening to music at low volume levels, this feature will boost the
bass and treble ranges to compensate for the characteristics of human
hearing. To adjust the Loudness settings, press the MENU button (22)
repeatedly until “LOUD” appears in the display. Press the TUNE/TRACK
>>| or |<< buttons (19) to access the following settings:
•
LOUD
Turn the rotary encoder to turn the Loudness feature ON/OFF.
•
LEVEL
Adjust gain to LOW, MID, or HIGH.
•
Peak Frequency (P. FREQ)
Turn the rotary encoder to adjust the Peak Frequency to 400Hz, 800Hz,
or 2.4KHz.
•
BOOST
Turn the rotary encoder to select “Flat” or “On” (Bass Boost).
Bass Quality Factor Curve Characteristics
Middle Quality Factor Curve Characteristics