JVC GC-A55 - Manual (Page 14)

[Back] [Next]
GETTING STARTED
Be sure to insert the (AA-size Alkaline) batteries before trying to capture images with your camera.
Inserting the Batteries
Notes :
l Please ensure that the batteries are inserted in the correct way. Do not reverse the +/ - polarities.
l The recommended battery type is AA size ALKALINE.
l Never use manganese batteries.
l Low temperatures (under 0°C or 32°F) will reduce the output efficiency of the batteries, thereby shortening the operation time of the
camera.
l The use of Flash is not recommended when the battery level is low.
l Never mix old and new batteries.
l Remove the batteries if the camera is not to be used for an extended period of time, to prevent leaks or corrosion.
l Before discarding batteries, cover the positive and negative terminals with adhesive tape.
l The Battery Indicator reflects the level of remaining battery power. When the indicator appears as shown above, the batteries are
weak and need to be replaced.
l When you use your camera as a video camera for your PC, batteries in the camera are necessary even though power is supplied
through the USB cable.
Attaching the Hand Strap
Always use the provided hand strap when carrying the camera. Please note that the company cannot be held responsible for any
accidental drop of the camera due to improper use of the hand strap.
To attach the strap to your camera:
1. Thread the thinner looped end of the strap through the strap holder.
2. Insert the other end of the strap through the thin loop and pull it all the way out. Ensure that the strap is securely tightened unto the
camera.
Note :
Be careful not to bump the camera or entangle the strap.
Inserting and Removing the SD / Multimedia Card
1. Slide the Battery/Memory card compartment door (located on the right side of the camera) in the
direction indicated by the arrow to open it.
2. Insert the AA-size batteries as indicated on the inner side of the door.
3. Close back the door and turn on the camera.
Checking Batteries( :Full battery power)
The battery indicator will be displayed on the status LCD panel while the camera is on. Depending
on the durability and usage of the batteries, the number of pictures that can be recorded varies.
Note that power is consumed by the following operations even when not recording, reducing the
number of images that can be recorded :
l Extensive use of the LCD monitor in the Play/Delete mode.
l Performing settings.