JVC LVT1150-003B - Manual (Page 15)

Connections
10
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
Connecting the satellite (front, center, surround)
speakers
Before connecting the speaker
cords;
Twist and pull the insulation coat off and
remove.
Powered subwoofer
SP-PWSW9
Surround speakers
SP-THS9S
Center speaker
SP-THS9C
Copper
Black
Silver
Red
Front speakers
SP-THS9F
4 m
10 m
4 m
• Connect the silver cords to the black (r) terminals.
• Connect the copper cords to the (q) terminals referring
to the table below:
Speaker cord (supplied)
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Wired connection
When you perform Smart
Surround Setup function
(
A pg. 20), connect the
surround speakers to the
powered subwoofer, not to the
wireless receiver unit.
Wireless receiver
unit RX-THSW8
Continued on next page
This page is for
TH-SW9SW8[B]-04Start.fm Page 10 Monday, April 12, 2004 11:49 AM