JVC LVT1150-003B - Manual (Page 14)

Connections
9
The following procedure explains the front speaker assembly. The
assembly of both the front and surround speakers are done in the
same manner.
NOTE
• The stands and the base plates are commonly used for both front and
surround speakers assembly.
Before assembling —
• Prepare a Phillips screwdriver (not supplied).
• Take care not to drop the base plate while assembling; otherwise,
it may cause damage to the floor or injury.
1
• You can route the speaker cords through one of the three
grooves on the base plate depending on the speaker layout.
• Depending on the installing condition, you can assemble the
front and surround speakers without the stands. In such a
case, attach the speaker directly to the base plate instead of
the stand.
2
3
Completion
Assembling the front and
surround speakers
Base plate ( ×4)
Stand ( ×4) Front speaker
( ×2)
Surround speaker
( ×2)
Stand
Speaker cord
(supplied)
Base plate
Bottom
Black
Red
Silver
Screw M5 x 25 mm (supplied)
Copper
Speaker
Stand
Black
White
Screw M5 x 25 mm
(supplied)
with stand without stand
This page is for
TH-SW9SW8[B]-04Start.fm Page 9 Thursday, April 1, 2004 11:49 AM