Jensen UV8 User Manual
Page 26
22
UV8
Error Messages
Care and Maintenance
1.
Use only a clean silicone cloth and neutral detergent to
clean the front panel or monitor. A rough cloth and non-
neutral detergent (such as alcohol) may result in
scratching or discoloration.
2.
Do not get water or cleaning fluids on the unit.
3.
If the temperature inside the player gets too hot, a
protective circuit automatically stops play of the disc. If
this occurs, allow the unit to cool before operating the
player again.
4.
Never insert anything other than a 5” (12 cm) compact
disc into the player as the mechanism can be damaged
by foreign objects.
5.
Do not attempt to use a 3” (8 cm) CD-Single disc in this
unit, either with or without an adaptor, as damage to the
player and/or disc may occur. Such damage is not
covered by the Warranty on this product.
6.
The CD player may not operate properly in extreme hot
or cold. If such conditions occur, allow the interior of the
vehicle to reach a normal temperature before using
player.
7.
When the vehicle warms up during cold weather or
under damp conditions, condensation may appear on
the LCD panel. Should this occur, the screen will not
operate properly until the moisture has evaporated.
8.
We suggest you use a cleaning disc in this unit more
frequently than in the unit in your home due to the
environmental conditions of the vehicle.
Disc does not play back
Disc is warped or scratched
Use disc in good condition
Disc is dirty or wet
Clean disc with soft cloth
Laser pickup is dirty
Clean laser pickup with cleaning disc
Incompatible disc is used
Use compatible disc
Disc rating exceeds Parental Lock rating limit
Change Parental Lock settings to lower restriction
Disc region code is not compatible with unit
Use disc with proper region code
Disc is inserted upside down
Insert disc with label side up
PBC cannot be used during VCD playback
PCB is not available on the disc
No repeat or searching while playing VCD
PCB is on
Turn PCB off
MP3
Interruption occurred during playback
Disc is dirty or scratched
Clean disc or replace
File is damaged/bad recording
Recreate disc with good files
Incorrect playback message displayed
Message is longer than LCD can display
Table 7: Troubleshooting
Problem
Cause
Corrective Action
Table 8: Error Messages
Message Displayed
Cause
Corrective Action
Loading
Disc is being read
No Disc
Disc is dirty
Clean disc with soft cloth
Disc is upside down
Insert disc with label side up
Disc not present in loading compartment
Insert disc
Bad Disc
Disc is dirty
Clean disc with soft cloth
Disc is upside down
Insert disc with label side up
Unknown disc
Disc format is not compatible with this unit
Region Error
DVD is not compatible with region code of unit
Error
Illegal mechanism operation
Press EJECT key for 5 seconds to reset loading mechanism