JVC TK-C1430 - Manual (Page 6)

E-6
Ⅲ A DSP (Digital Signal Processor) features
a Extended Dynamic Range (ExDR) and
enables to shoot both bright and dark
locations.
Ⅲ The use of a CCD with a SENSE UP (X32)
function realized the minimum luminous
flux density for subject of 0.9 lx (F1.2,
50%, AGC 20dB) and 0.03 lx (at SENSE
UP (X32)). Furthermore, we realized 0.03
lx (F1.2, 50% AGC 20dB) thanks to the
function of B/W mode.
Ⅲ A motion detector function detects the
motion inside an image and emits alarm
signals.
Ⅲ The equipped Y/C terminals and RS-
422A/RS-485 terminals allow intended
compatibility with diversified systems.
Ⅲ Day/Night surveillance
When the light is low, the camera pictures
can be switched automatically to black
and white pictures.
Ⅲ Electronic zoom
The 10x electronic zoom allows
monitoring in far greater detail.
Features
Ⅲ Before starting an important recording,
be sure to perform a test recording in
order to confirm that a normal
recording is possible.
Ⅲ We do not accept liability for the loss of
a recording in the case of it becoming
impossible to record due to a problem
in the video camera, VCR or video tape.
Ⅲ We do not accept liability for any
damage to the camera in cases where
it is dropped because of bad installation
due to failure to observe the installation
instructions correctly. Please be careful
when installing the camera.
Ⅲ The motion detector is not a feature
which prevents theft, fire, etc. Even if
an accident should occur resulting in
damage, we do not accept any liability.
INTRODUCTION
Characters and symbols used in this instruction manual.
CAUTION : Cautionary notes concerning operation of the unit.
MEMO : Reference such as restrictions of features, etc.
੬ : Reference page or item.
TK-C1430_06-22_E 05.6.20, 10:40 AM 6