JVC TK-C1430 - Manual (Page 40)

E-40
MODE S EL E C T
CAMERA T I T L E ED I T
RE V ERS E MODE
OF F
AL M . T I T L E S Z E I D OUBLE
AL A RM COLOUR WH I T E
AU X T E R M I N A L (B&W IN)
D. Z O O M M A X x2
H L I M O D E O F F
. .
Output of Black-White/Colour switching signal
It is possible to output black-white/colour switching signal from the AUX terminal on the back
of this unit. Perform the following settings.
Ⅲ Set the B&W Item to AUTO.
1.
Select the B&W/COLOUR MODE item
on the ALC SETTING screen.
2.
Press the SET button.
The B&W/COLOUR MODE screen
appears.
3.
Press either the button or the
button and select the B&W item.
4.
Press either the button or the
button and set to “AUTO”.
5.
Upon completion of setting, press the
MENU button twice.
Then, the MAIN MENU screen is
brought back.
Ⅲ Set the AUX TERMINAL Item to
B&W OUT.
1.
Select MODE SELECT on the MAIN
MENU screen.
2.
Press the SET button.
The MODE SELECT screen appears.
3.
Press either the button or the
button and select the AUX TERMINAL
item.
4.
Press either the button or the
button and set to ”B&W OUT”.
5.
Upon completion of setting, press the
MENU button twice.
• Then, the normal screen is brought
back.
B&W
N ORMAL
A UT O
B&W/COLOUR MODE
AU TO L E V E L
CAMERA
SETUP
SET
MENU
AWC
SET button MENU button
MEMO
• When you use infrared illumination, if the
subject excessively reflects, a B/W screen
can switch to a colour screen.
To perform switching with higher accuracy,
we recommend that you use it by the setting
mentioned in [Control by Black-White/
Colour Switching Signal From the Outside],
referring to Page 41.
CAUTION:
When you use near infrared ray illumi-
nations, use a lens that is compatible
with the near infrared ray illuminations.
Any lens other than the compatible one
can result in out-of-focus due to such
characteristics.
TK-C1430_23-44_E 05.6.20, 10:42 AM 40