JVC AV-48WP30 - Manual (Page 57)

NUMBER BUTTONS - 10 KEY PAD
Use the number buttons on the remote control to move directly to a specific channel. For
example, to move to channel 7:
0 (Zero)
7 (Seven)
Button Functions
100+ BUTTON
Use the 100+ button to directly access channels above Channel 99. For example, to move to
channel 124:
100+
2 (Two)
4 (Four)
RETURN+
The R ETURN + button has two functions:
Return - Returns to the channel viewed just before the channel currently onscreen.
Return+ - Lets you program a specific channel to return to while scanning through the
channels. To program:
R ETURN + and hold for three seconds.
You can now scan through the channels using the C H +/- buttons.
R ETURN +
You will return to your programmed channel.
• To cancel your R ETURN + channel, press and hold the R ETURN + button for three seconds. The
message “RETURN CHANNEL CANCELLED!” will appear.
• R ETURN + works only with C HANNEL +/-. Pressing any number key will cancel R ETURN +.
RETURN CHANNEL
PROGRAMMED !
V-CHIP
By pressing the remote control V- CHIP button, the V-chip rating information for the program
which is being received is displayed on the screen.
If the V-chip rating information is not being sent, “UNRATED” is displayed on the screen.
If the zero (“0”) button is pressed while the V-chip rating is displayed on the screen, all
categories with the same or a higher V-chip rating will be blocked.
For example, if you block movies rated NC-17, movies rated X will also be blocked.
• V-chip blocks can be manually set one at a time by using the V-chip option in the INITIAL
SETUP menu. For detailed information about V-chip ratings and V-chip manual settings, refer
to pages 33 to 38.
57