Initial setup, Vertical position, Exit – JVC AV-48WP30 User Manual
Page 49: Initial setup 3
Initial Setup
INITIAL SETUP
NEXT PAGE
PREVIOUS
OPERATE BY
EXIT BY
SELECT
EXIT
BY
XDS ID
CONVERGENCE
CENTER CH INPUT
VERTICAL POSITION
OFF
ON
POWER INDICATOR
JVC
LOW HIGH
OFF
ON
INITIAL SETUP Menu
Access the onscreen menus by pressing M
ENU
on your remote control. You may then either
use the up and down arrows to scroll to the INITIAL SETUP menu, or press M
ENU
until
the INITIAL SETUP screen appears. Use the arrows to move to the setting you wish to
change. You can make adjustments to any or all of the settings
.
49
Initial Setup 3
If you select the regular size with ASPECT, VERTICAL POSITION option is not viewed.
This option allows you to adjust the vertical position of the picture on the screen. You can raise
or lower the orientation of the picture by pressing the or arrows to move the picture up or
down. When the picture is positioned the way you would like, press E
XIT
to save your settings
and leave this option.
VERTICAL POSITION
Vertical Position
VERTICAL POSITION allows you to adjust the screen position vertically when the ASPECT is
set to PANORAMA, CINEMA or FULL.
Press the M
ENU
button
to VERTICAL POSITION
¥
to operate
To adjust VERTICAL POSITION
NOTE: When the color of the mark changes to pink, it is impossible to adjust the position.
PANORAMA
EXIT BY
OPERATE BY
EXIT