JVC RX-554RBK - Manual (Page 9)

4
English
Connecting the FM and AM (MW/LW) Antennas
FM Antenna Connections
Notes :
• Make sure the antenna
conductors do not touch any
other terminals, connecting
cords and power cord. This
could cause poor reception.
• If reception is poor, connect an
outdoor single vinyl-covered
wire to the AM EXT terminal.
(Keep the AM (MW/LW) loop
antenna connected.)
Note:
If reception is poor, connect the
outside antenna.
Before attaching a 75
Ω coaxial
cable (the kind with a round wire
going to an outside antenna),
disconnect the supplied FM wire
antenna.
AM (MW/LW) Antenna Connections
Turn the loop until you have
the best reception.
Snap the tabs on the loop into
the slots of the base to assemble
the AM (MW/LW) loop.
Outdoor Single Vinyl-
covered Wire
A. Using the Supplied FM Antenna
The FM antenna provided can be connected to the FM 75
Ω
COAXIAL terminal as
temporary measure.
B. Using the Standard Type Connector (Not supplied)
A standard type connector (IEC or DIN45325) should be connected to the FM 75
Ω
COAXIAL terminal.
AM (MW/LW) Loop Antenna
AM
LOOP
ANTENNA
AM
EXT
GND
FM 75
COAXIAL
2 3 1
AM
EXT
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
AM
LOOP
ANTENNA
GND
FM 75
COAXIAL
A. B.
Extend the FM antenna horizontally.
FM Antenna
Outside FM Antenna wire
RX-554RBK(EE)_0118-001A_En01-23 98.1.30, 2:19 PM 4