JVC RX-554RBK - Manual (Page 19)

14
English
One Touch Operation
This receiver can memorize the optimum sound settings for each playing source.
About the One Touch Operation
JVC’s One Touch Operation function is used to assign and store different sound settings
for each different playing source. By using this function, you do not have to change the
settings every time you change the source. The stored settings for the newly selected
source are automatically recalled.
The following can be stored for each source:
•
Volume level (see page 10)
• Balance (see page 12)
• Loudness (see page 12)
• Preset SEA modes (see page 24)
• 3D-PHONIC mode settings (see page 27)
• DAP mode settings (see page 29)
• Surround mode settings (see page 36)
Using the One Touch Operation
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights up, then
the previously memorized settings are recalled and
appear on the display in turn.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings
for the currently selected source is recalled, and appears on
the display when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes
off.
(Even though the One Touch Operation function is canceled, the recalled sound effects
remain active.)
ONE TOUCH OPERATION
ONE TOUCH
OPERATION
Note:
• If the source is TUNER/BAND,
the One Touch Operation
function memorizes the settings
each for the FM and AM band.
• The DAP mode, surround mode
and 3D-PHONIC mode cannot
be used at the same time.
RX-554RBK(EE)_0118-001A_En01-23 98.1.30, 2:19 PM 14