JVC RX-554RBK - Manual (Page 21)

16
English
5. Repeat steps 1 to 4 until you store all the stations
you want.
To cancel a stored preset station
Storing a new station on a used number erases the previously stored one.
To tune in a preset station
On the front panel:
1. Press TUNER/BAND so that the Control
% % % % % / fi fi fi fi fi / @ @ @ @ @ /
# # # # # buttons work for tuner settings.
The lamp above the button lights up.
2. Press Control
% % % % % / fi fi fi fi fi until “–PRESET+” appears on
the display.
3. Press Control
@ @ @ @ @ / # # # # # to select a preset channel.
Each time you press the button, the preset channels change.
• Pressing Control
@ changes preset channels in
decreasing order.
• Pressing Control
# changes preset channels in
increasing order.
From the remote control:
1. Press TUNER/BAND.
Each time you press the button, the band alternates
between FM and AM (MW/LW).
2. Press 10 keys to select a preset channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 20, press +10 then 10.
• For channel number 30, press +10, +10, then 10.
TUNER/BAND
TUNER/
BAND
4 5 6
1 2 3
EFFECT DELAY
3D-PHONIC SURROUND
TEST
7/P 8 9
10 +10
– + CENTER
– +
REAR
DAP MODE
SEA MODE
Note:
If you adjust the sound by using
SOUND CONTROL while
listening to a station, the 10 keys
will work for adjusting the sound.
To select a preset channel number
after the sound adjustment, press
TUNER/BAND again, so the 10
keys will work for selecting the
preset channel numbers.
RX-554RBK(EE)_0118-001A_En01-23 98.1.30, 2:20 PM 16