JVC CA-WMD90R - Manual (Page 55)

– 50 –
There are three timers available — Recording Timer, Daily
Timer, and Sleep Timer.
Before using these timers, you need to set the clock built in
the unit. (See page 11.)
Using Recording Timer
With Recording Timer, you can make an MD of a radio
broadcast automatically. You can set three Recording Timer
separately.
• You can set Recording Timer whether the unit is turned
on or off.
• To correct a mis-entry any time during the setting
process, press CANCEL.
If the CANCEL button does not work, press CLOCK/
TIMER repeatedly and start from step 1 again.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
station, turns off the volume, and starts recording on the
MD when the timer-on time comes. Then, when the timer-
off time comes, the unit automatically turns off (stands by).
Recording Timer works only once, but the timer settings
remain stored in memory until you reset them or disconnect
the AC power cord.
1
Press CLOCK/TIMER repeatedly to select Timer
Recording 1, 2 or 3 setting mode.
• Each time you press the button, the timer mode
changes as follows:
Turns on/off Daily Timer.
Sets Daily Timer.
Turns on/off Recording
Timer 1.
Sets Recording Timer 1.
Turns on/off Recording
Timer 2.
Sets Recording Timer 2.
Turns on/off Recording
Timer 3.
Sets Recording Timer 3.
Sets the clock (see page
11).
2
Rotate the right jog dial to set the hour of the timer-
on time, then press SET.
3
Rotate the right jog dial to set the minute of the
timer-on time, then press SET.
4
Rotate the right jog dial to set the hour of the timer-
off time, then press SET.
5
Rotate the right jog dial to set the minute of the
timer-off time, then press SET.
6
Rotate the right jog dial to select a preset station
channel number, then press SET.
7
Rotate the right jog dial to select a recordable MD in
deck B, then press SET.
The corresponding REC (1, 2, 3) indicator stops
flashing and remains lit. The settings you have done are
shown in the main display in sequence.
• You can select “MD 1,” “MD 2,” “MD 3,” and “MD
ALL.” When you select “MD ALL,” recording will
be done on all loaded MDs continuously.
8
Press to turn off the unit (on standby) if
necessary.
To stop recording any time, press
7 on MD deck B.
After a timer recording is complete...
Set the volume to an appropriate listening level.
• While recording volume is turned off, and will not be restored
automatically.
To turn on or off Recording Timer after its setting is
done
1 Press CLOCK/TIMER repeatedly until “REC1,”
“REC2,” or “REC3,” which you want appears in the
main display.
2 To turn off the Recording Timer, press CANCEL.
The corresponding REC (1, 2, 3) indicator goes off
from the display.
The Recording Timer is canceled, but the setting for the
Recording Timer remains in memory.
To turn on the Recording Timer, press SET.
The corresponding REC (1, 2, 3) indicator lights up on
the display. The settings you have done are shown in
the main display in sequence for your confirmation.
Continued
DAILY on/off
DAILY setting mode
REC1 on/off
REC1 setting mode
REC2 on/off
REC2 setting mode
REC3 on/off
REC3 setting mode
Clock setting mode
Timer/Clock setting
mode is canceled
EN49-58.CA-WMD90R[E]/f 99.4.1, 6:01 PM 50