JVC CA-WMD90R - Manual (Page 20)

– 15 –
English
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and tunes in the
previously tuned station (either FM or AM–MW/LW).
• Each time you press the button, the band alternates
between FM and AM (MW/LW).
2
Select a preset number.
On the unit:
Rotate the right jog dial.
• Clockwise: to increase the preset numbers.
• Counterclockwise: to decrease the preset numbers.
On the remote control:
Press the number buttons.
• Make sure that you have pressed FM/AM on the
remote control before pressing the number buttons.
For preset number 5, press 5.
For preset number 15, press +10, then 5.
For preset number 20, press +10, then 10.
Receiving FM Stations with RDS
RDS allows FM stations to send an additional signal along
with their regular program signals. For example, the
stations send their station names, as well as information
about what type of program they broadcast, such as sports
or music, etc.
When tuned to an FM station which provides the RDS
service, the RDS indicator lights up on the display.
With the unit, you can receive the following types of RDS
signals.
PS (Program Service):
Shows commonly known station names.
PTY (Program Type):
Shows types of broadcast programs.
RT (Radio Text):
Shows text messages the station sends.
EON (Enhanced Other Networks):
Provides the information about the types of the
programs sent by other RDS stations than the one
being received.
More about RDS
• Not all FM stations provide RDS signals, nor do all RDS
stations provide the same services. If in doubt, check with local
radio stations for details on RDS in your area.
• RDS may not work correctly if the received station is not
transmitting the signals properly or if the signal strength is
weak.
Changing the RDS Information
You can see RDS information on the display while
listening to an FM station.
• RDS operations are possible only using the remote
control.
1
Press RDS CONTROL while listening to an FM
station.
2
Press DISPLAY.
• Each time you press the button, the display changes
to show the following information:
If No PS, PTY, or RT signals are sent by a station
“no PS,” “no PTY” or “no RT” appears in the main display.
If the unit takes time to show the RDS information
received from a station
“wait PS”, “wait PTY”, or “wait RT” may appear on the display.
PS
(Program Service)
PTY
(Program Type)
RT
(Radio Text)
Station frequency (non-RDS)
EN10-22.CA-WMD90R[E]/f 99.4.1, 6:00 PM 15