JVC CA-WMD90R - Manual (Page 25)

– 20 –
English
When using the remote control, make sure that it is ready
for CD operations.
• Pressing CD 1, CD 2, CD 3, or CD
6 on the remote
control makes the remote control ready for CD
operations.
Loading CDs
1
Press one of the open/close buttons (
0) for the disc
tray (CD 1 to CD 3) you want to load a CD onto.
The unit automatically turns on and the selected disc
tray comes out. The corresponding CD number lamp
(CD 1 to CD 3) lights.
2
Place a disc correctly on the circle of the disc tray,
with its label side up.
• When using a CD single (8 cm), place it on the
inner circle of the disc tray.
3
Press the same open/close button (
0) you have
pressed in step 1.
The disc tray closes.
4
Repeat steps 1 to 3 to place other CDs.
When loading more than one CD continuously
Press the open/close button (
0) for the next tray you want to place
a CD onto. The first disc tray automatically closes and the next
disc tray comes out.
About the CD number lamps (CD 1 to CD 3 buttons)
Each disc number lamp corresponds to the disc tray of the same
number.
• It lights green when you press
0 and when the unit has
recognized that there is a CD on the corresponding disc tray.
• It goes off when the unit has recognized that there is no CD on
the corresponding disc tray.
• It flashes while a CD on the corresponding disc tray is played
back or paused.
Good No good
Playing Back the Entire Discs — Continuous
Play
You can play CDs continuously.
1
Load CDs.
2
Press one of the CD number buttons (CD 1, CD 2
and CD 3) for the disc you want to play.
CD playback starts from the first track of the selected
disc.
• Pressing
# / 8 for the CD player (or CD 6 on the
remote control) instead of the CD number buttons
starts playing back the currently selected CD.
To stop during play, press
7 for the CD player.
To remove the disc, press the corresponding open/close
buttons (
0).
CD playback sequence
When 3 CDs are loaded on the disc trays, they are played in one of
the following sequences.
• When CD 1 is pressed : CD 1
] CD 2 ] CD 3 (then stops)
• When CD 2 is pressed : CD 2
] CD 3 ] CD 1 (then stops)
• When CD 3 is pressed : CD 3
] CD 1 ] CD 2 (then stops)
* If no CD is on the disc trays, CD player skips that tray.
Basic CD Operations
While playing a CD, you can do the following operations.
To exchange CDs during playback of another
Press the open/close button (
0) corresponding to a CD
number not currently being played to eject that disc tray
and exchange the CD.
If CDs are exchanged during playback, playback will stop
after playing all newly inserted CDs.
To stop playback for a moment
Press
# / 8 for the CD player (or CD 6 on the remote
control).
To resume play, press # / 8 for the CD player (or CD 6
on the remote control) again.
This shows the currently selected disc.
Track No. Elapsed playing time
Continued
EN10-22.CA-WMD90R[E]/f 99.4.1, 6:00 PM 20