JVC RX-E11S - Manual (Page 21)

19
Basic settings
Setting the digital input (DIGITAL IN)
terminals—DIGITAL IN1/2/3
When you use the digital input terminals, register what
components are connected to which terminals—DIGITAL IN1/2/3
(see page 9) so that the correct source name will appear when
you select the digital source.
Select one of the following components for each terminal:
DVR/DVD For DVD recorder or DVD player.
DBS For DBS tuner.
VCR For VCR.
TV For TV.
Initial setting: DVR/DVD (for “DIGITAL IN1”)
DBS (for “DIGITAL IN2”)
VCR (for “DIGITAL IN3”)
NOTES
• You cannot assign the same component for different terminals.
The priority order for assignment is as follows:
“DIGITAL IN1” > “DIGITAL IN2” > “DIGITAL IN3.”
Ex.: When “DIGITAL IN1” is set to “DVR/DVD”
For “DIGITAL IN2,” “DBS,” “VCR,” and “TV” are selectable.
In this case, “VCR” is selected.
For “DIGITAL IN3,” “DBS” and “TV” are selectable.
: Selectable : Not selectable
• Setting “DIGITAL IN1” affects “DIGITAL IN2” and “DIGITAL IN3”
settings. When you have changed “DIGITAL IN1,” confirm the
components assigned to “DIGITAL IN2” and “DIGITAL IN3.”
Setting Auto Surround—AUTO SURRND
You can enjoy the Surround mode simply by selecting the source
(with digital input selected for that source).
• Auto Surround also works when the input mode changes from
analog to digital.
• For details about the Surround/DSP modes, see pages 25 to 27.
Select “AUTO SR: ON” when activating Auto Surround.
AUTO SR: ON
The AUTO SR indicator lights up on the display.
• If a multi-channel signal comes in, an appropriate
Surround mode will be turned on.
• If a Dolby Digital 2-channel or DTS 2-channel signal
with surround signal comes in, “PLII MOVIE” will be
selected.
• If a Dolby Digital 2-channel or DTS 2-channel signal
without surround signal comes in, “SURRND OFF
(stereo)” will be selected.
• If a Linear PCM signal comes in, nothing will
change.
AUTO SR:OFF
Select to deactivate Auto Surround.
Initial setting: AUTO SR:OFF
NOTES
• This function does not take effect in the following cases:
– While playing an analog source,
– While selecting any of DSP modes (see page 27), or one of
the fixed digital decode mode—“DGTL D.D.” or “DGTL DTS”
(see page 11), and
– While listening with the headphones.
• If you press SURROUND with Auto Surround activated, Auto
Surround will be canceled temporarily for the currently selected
source.
Auto Surround setting will be restored in the following cases:
– When you turn the receiver off and on,
– When you change the source,
– When you change the analog/digital input, and
– When you select “AUTO SR: ON” again.
DVR/DVD DIGITAL IN1 DBS VCR TV
DIGITAL IN2 DVR/DVD DBS VCR TV
DIGITAL IN3 DVR/DVD DBS VCR TV
EN14-19RXE11S[US_UX]2.p65 06/12/2004, 21:38 19