beautypg.com

Jet Tools DC-1200CK User Manual

Page 14

background image

14

Changing Operating Frequency

If several devices are controlled by the same type
remote control unit, each remote control unit can be
set to operate at its' own unique operating frequency
as follows:

Referring to Figure 15:

1. Unplug the DC-RC230 Remote Power Control

unit.

2. Remove the back covers of the main unit (A) and

remote control switch

(B).

3. Locate

the

DIP switch

(C) in each unit.

4. Change the position of the DIP switches in the

main unit

(A) to any combination desired as long

as they are not the same as other units that may
be present and located within the radio frequency
range.

5. Set the DIP switches (C) in the remote control

switch

(B) to match the switch settings in the

main unit

(A).

6. Replace the back covers to the main unit and

remote control switch.

7. Operate a device as described in Turning the

DC-RC230 On & Off

and verify that other devices

using the same type remote control do not turn
on.

Figure 15

Installing the DC-RC Remote Power
Control

The DC-RC230 Remote Power Control unit can be
placed anywhere for convenience and portability if
used to control other machines or it can be mounted
as a permanent part of a machine, such as the DC-
1200 Dust Collector.

To mount the DC-RC230 Remote Power Control
(refer to Figure 16):

Note:

Mounting hardware is not included and must

be supplied by the machine’s owner or user.

1. Place RC Power Control Unit (A) on the open

clearing of the base (B) of the dust collector near
the motor (C).

2. Using a marker, mark the base through the

mounting holes of the power control units
mounting tabs.

3. Drill two holes (D) through the base where

marked.

4. Insert screws through the tabs and base. Place

washers and hex nuts on the threaded ends of
the screw underneath the base and tighten.

Figure 16