beautypg.com

Canister kit assembly – Jet Tools DC-1200CK User Manual

Page 12

background image

12

Canister Kit Assembly

If you purchased Model DC-1200CK or DC-1200CK-3
Dust Collector, this section describes the assembly
and installation of the contents of the Canister Kit
(SN 708636F).

Canister Filter

1. Mount the handle onto the canister filter with two

M10 hex nuts, two M10 flat washers, and a M10
lock washer (Figure 10).

2. Mount the canister filter on top of the collector

housing

(A, Fig. 5) and tighten the knobs on the

canister filter

(Figure 10).

Collector Bag

3. Place the ring over the top of the plastic bag and

fold over the bag approximately three inches,
Figure 11.

4. Insert the snap ring (A, Fig. 12) of the collector

bag into the bottom of the housing at an angle.

5. Pull down on the ring to make sure it “seats” in the

housing.

Note:

make sure the snap ring “snaps” into place

in the housing, and also that the plastic bag hangs
down approximately 3” so that there are no air
leaks.

Figure 10

Figure 11

Figure 12