JVC CA-NXCDR7R User Manual
Page 48
– 43 –
CD RW
UNFINALIZE DISC
dB
REC LEVEL
FINALIZE DISC
3
2
1
Recording Track Marks Manually
—Manual Track-Marking
When auto track-marking is activated (initial setting at the
factory), track marks are recorded automatically (see “Auto
track-marking” on page 32 for more details).
To cancel auto-track marking and use manual track
marking, follow the procedure below.
On the remote control ONLY:
1
Press MENU repeatedly until “AUTO TRACK”
appears in the main display.
• Each time you press the button, the following menu
items appear as follows:
2
Press SET.
The current setting for auto-track marking appears.
3
Press
¢ or 4 to select “AUTO TRACK OFF”
then press ENTER.
The AUTO TRACK indicator goes off from the display,
and auto track-marking is canceled, and now you can
put track marks manually during recording.
• To put track marks during recording, press SET at
the point where you want to put a track mark.
To restore auto track-marking, repeat steps 1 to 2 and
select “AUTO TRACK ON” then press ENTER in step 3.
• The AUTO TRACK indicator lights on the display.
About manual track-marking
• Track marks must be recorded apart from each other by 4
seconds. If you press SET twice within 4 seconds, the second
press of the button will be ignored (only one track mark will be
recorded where you press SET for the first time).
• You cannot put track marks manually during CD Synchronized
Recording. (Auto track-marking is activated temporarily.)
Ex.: When auto-track marking is activated (initial setting)
By pressing MENU, you can use (or cancel) the following
convenient CD Recorder functions:
AUTO TRACK: Selects either auto-track marking or
manual track marking (see the right
column.)
TRACK SPACE: Automatically places a 2-second blank
space at the beginning of each track on
a recorded disc (see page 44).
CONVERTER:
Turns on or off the built-in sampling
frequency rate converter (see page 44).
TRACK SKIP:
Records a skip mark to an unwanted
track so that it will be skipped (ignored
as if it does not exist) during play (see
page 45).
TRACK ERASE: Erases the unwanted tracks on a CD-
RW (see page 45).
DISC ERASE:
Erases all the recorded tracks on a CD-
RW (see page 46).
UNFINALIZE:
Erases the TOC (Table of Contents) of a
finalized CD-RW (see page 46).
Before using the following functions explained in this
section, make sure of the following.
• The following procedures are only possible when
CD Recorder is selected as the source and
playback is not started.
• To stop any time during the following procedures,
press CANCEL.
TRACK ERASE
=
DISC ERASE
=
UNFINALIZE
=
TRACK SKIP
=
AUTO TRACK
=
TRACK SPACE
=
CONVERTER
=
Canceled
=
(back to the beginning)
EN42-46_CA-NXCDR7R[B]_f
01.7.23, 10:01 AM
43