beautypg.com

Before installation, English – JVC RX-5032VSL User Manual

Page 4

background image

1

English

VOLTAGE SELECTOR

220V

230

-

240V

127V

110V

Precautions

General precautions

• DO NOT insert any metal object into the unit.
• DO NOT disassemble the unit or remove screws, covers, or

cabinet.

• DO NOT expose the unit to rain or moisture.

Locations

• Install the unit in a location that is level and protected from

moisture.

• The temperature around the unit must be between –5˚C and

35˚C.

• Make sure there is good ventilation around the unit. Poor

ventilation could cause overheating and damage the unit.

Handling the unit

• DO NOT touch the power cord with wet hands.
• DO NOT pull on the power cord to unplug the cord. When

unplugging the cord, always grasp the plug so as not to
damage the cord.

• Keep the power cord away from the connecting cords and

the antenna. The power cord may cause noise or screen
interference. Coaxial cable is recommended for the antenna
connection, since such cable is well-shielded against
interference.

• When a power failure occurs, or when you unplug the power

cord, the preset settings such as preset FM or AM channels
and sound adjustments may be erased within a few days.

Before Installation

This mark indicates that ONLY the remote
control CAN be used for the operation
explained.

Remote

NOT

Checking the Supplied Accessories

Check to be sure you have all of the following supplied
accessories. The number in parentheses indicates the
quantity of each piece supplied.

• Remote control (1)

• Batteries (2)

• AM loop antenna (1)

• FM antenna (1)

• AC Plug Adaptor (1)

If anything is missing, contact your dealer immediately.

Setting the Voltage Selector Switch

Before connections, always do the following first if necessary.

Select the correct voltage in VOLTAGE SELECTOR on the
rear by using a screw driver. Check to be sure if the voltage
mark is set to the voltage for your area where this unit plugs
in.

Voltage mark

This mark indicates that the remote control
CANNOT be used for the operation explained.
Use the buttons on the front panel.

01-09_RX-5032V[US]f

03.2.5, 18:58

1