J. T. Eaton Liquid-Cooled Drives LCX9000 - Manual (Page 67)

LCX9000 Liquid-Cooled Drives User Manual
MN04005001E For more information visit: www.EatonElectrical.com 4-9
January 2007
Figure 4-12: Jumper Selection for OPT-A9
Note: If you change the AI signal content also remember to change the corresponding board
parameter in menu M7.
Jumper Block X1:
AI1 Mode
AI1 Mode: 0...20mA; Current Input
A B C D
A B C D
A B C D
AI1 Mode: Voltage Input; 0...10V
AI1 Mode: Voltage Input; 0...10V (Differential)
AI1 Mode: Voltage Input; -10...10V
A B C D
Jumper Block X6:
AO1 Mode
AI1 Mode: 0...20mA; Current Output
A B C D
A B C D
AO1 Mode: Voltage Output; 0...10V
= Factory Default
Jumper Block X2:
AI2 Mode
AI2 Mode: 0...20mA; Current Input
A B C D
A B C D
A B C D
AI2 Mode: Voltage Input; 0...10V
AI2 Mode: Voltage Input; 0...10V (Differential)
AI2 Mode: Voltage Input; -10...10V
CMB Connected to GND
A B C D
Jumper Block X3:
CMA and CMB Grounding
CMA Connected to GND
CMB Isolated from GND
CMA Isolated from GND
CMB and CMA
Internally Connected Together,
Isolated from GND