JVC GR-DVL315 - Manual (Page 56)

56
EN
TROUBLESHOOTING (cont.)
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
32. The LCD monitor image is
distorted.
33. Images on the LCD
monitor are jittery.
34. Blocks of noise appear
during playback, or there is
no playback picture and
the screen becomes blue.
35. The LCD monitor, the
viewfinder and the lens
have become dirty (ex.
fingerprints).
36. An unusual mark appears.
37. An error indication
(E01 — E06) appears.
38. The charger indicator on
the camcorder does not
light.
39. When the image is printed
from the printer, a black
bar appears at the bottom
of the screen.
40. When the camcorder is
connected via the DV
connector, the camcorder
does not operate.
32. •During playback of the
unrecorded portion, High-
speed Search and still
playback, LCD monitor
indications appear distorted.
This is not a defect.
33. •The speaker volume is too
great.
34.
————
35.
————
36.
————
37. •A malfunction of some kind
has occurred. In this case
the camcorder’s functions
become unusable.
38. •The temperature of the
battery is extremely high/
low.
•Charging is difficult in
places subject to extremely
high/low temperatures.
39. •This is not a malfunction.
40. •The DV cable was plugged/
unplugged with power
turned on.
32.
————
33. •Turn the speaker volume
down (
੬
pg. 18).
34. •Clean the video heads with
an optional cleaning
cassette (
੬
pg. 64).
35. •Wipe them gently with soft
cloth. Wiping strongly can
cause damage (
੬
pg. 57).
36. •Check the section of the
manual that explains LCD
monitor/viewfinder
indications (
੬
pg. 60 – 62).
37. •Remove the power supply
(battery pack, etc.) and wait
a few minutes for the
indication to clear. When it
does, you can resume using
the camcorder.
If the indication remains
even though you repeat the
above two or three times,
please consult your nearest
JVC dealer.
38. •To protect the battery, it is
recommended to charge it
in places with a temperature
of 10°C to 35°C (50°F to
95°F) (
੬
pg. 63).
39. •By recording with “DIS”
activated (
੬
pg. 32) this
can be avoided.
40. •Turn the camcorder’s power
off and on again, then
operate it.