JVC GR-DVL315 - Manual (Page 44)

44
EN
USING THE REMOTE CONTROL UNIT (cont.)
1
2
3
4
5
6
7
8
– – : – – ~
~
~
~
~
~
~
~
– – : – –
0 : 00 0
– –
TOTAL
CODE T I ME
N I OUT MODE
PLAY
REW
FF
ON/OFF IN/OUT
CANCEL
SELECT SCENES
4
Point the remote control at the camcorder’s remote
sensor. Press PLAY (4) and then press ON/OFF on
the remote control. The Random Assemble Editing
Menu appears.
5 At the beginning of the scene, press IN/OUT on the
remote control. The Edit-In position appears in the
Random Assemble Editing Menu.
6 At the end of the scene, press IN/OUT. The Edit-Out
position appears in the Random Assemble Editing
Menu.
7
Repeat steps 5 and 6 to register additional scenes.
•To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
NOTES:
● When choosing a scene, set Edit-In and Edit-Out points
so that there is a relatively large difference between
them.
● If the search time for an in-point exceeds 5 minutes, the
recording deck’s Record-Standby mode will be canceled
and editing will not take place.
● If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the
edited version.
● Since time codes register time only as accurately as
seconds, the time code total time may not match the
total program time exactly.
● Turning off the camcorder’s power erases all registered
Edit-In and Edit-Out points.
Random Assemble
Editing Menu
Program
Remote sensor
RM-V700U
(optional)