JVC GR-DVL160 - Manual (Page 60)

60
EN
SELECT SCENES
4
Point the remote control at the camcorder’s
remote sensor. Press PLAY ( 4 ) and then press
R.A.EDIT ON/OFF on the remote control.
The Random Assemble Editing Menu appears.
5
If using a Fade/Wipe at the beginning of the
scene, press FADE/WIPE on the remote control.
• Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
6
At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In position
appears in the Random Assemble Editing Menu.
7
At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random Assemble
Editing Menu.
8
If using a Fade/Wipe at the end of the scene,
press FADE/WIPE.
• Cycle through the effects by pressing repeatedly,
and stop when the one you want is displayed.
• If you select a Fade/Wipe effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
• When you use Fade/Wipe effects, that time is
included in the total time.
9
If using Playback Special Effects, press EFFECT
(
੬
pg. 56).
10
Repeat steps 6 through 9 to register additional
scenes.
• To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
• If you are not using Fade/Wipe or Programme AE
with special effects, repeat steps 6 and 7 only.
NOTES:
●
When choosing a scene, set Edit-In and Edit-Out points so that there is a relatively large difference between them.
●
If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be cancelled and
editing will not take place.
●
If there are blank portions before or after the Edit-In and Edit-Out points, a blue screen may be included in the edited
version.
●
Since time codes register time only as accurately as seconds, the time code total time may not match the total
programme time exactly.
●
Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.
● If you select Sepia or Monotone mode from Programme AE with special effects, you cannot use the Black & White
Fader. In this case the Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is
turned off. To combine these effects, use Sepia or Monotone during recording, then use the Black & White Fader
during Random Assemble Editing.
●
It is not possible to use Fade/Wipe effects and Programme AE with special effects during Random Assemble Editing
using a DV cable.
USING THE REMOTE CONTROL UNIT
(cont.)
1
2
3
4
5
6
7
8
– – : – – ~
~
~
~
~
~
~
~
– – : – –
0 : 00 0
– –
TOTAL
CODE T I ME
N I OUT MODE
PLAY
R.A.EDIT
ON/OFF
EFFECT
FADE/WIPE
EDIT IN/OUT
CANCEL
REW
FF
Random Assemble
Editing Menu
Programme
Remote sensor