John Lewis JLDWW 1203 - Manual (Page 23)

23
Starting a washing programme
Check that the baskets have
been loaded correctly and that
the spray arms can rotate freely.
Turn on the water tap.
Close the dishwasher door.
Press the ON/OFF button.
Select the desired cycle.
The cycle indicator and the respective cycle stages in the cy-
cle progress display will be illuminated. The remaining time
expected for the cycle will be shown in the multi-display.
The selected cycle will begin after approximately 3 seconds.
The current stage of the cycle is always shown in the cycle
progress display.
3
During the dishwashing cycle, the remaining time
shown in the multi-display may be adjusted according
to the size of the load, degree of soiling, etc.
Interrupting or cancelling a
washing programme in progress
1
Interrupt or cancel a washing programme in
progress only if it is absolutely necessary.
Interrupting or Cancelling a washing programme by
opening the dishwasher door:
1
Hot steam may escape when the door is opened.
There is a risk of scalding.
– Open the door carefully. The programme will stop.
– Close the door. The programme will start from the point
at which it was interrupted.
Cancelling a washing programme in progress
To cancel a washing programme you have to reset the dish-
washer; press simultaneously function buttons 1 and 2 and
keep them pressed.
The programme display for the current cycle will flash for
several seconds and then go out.
Release the function buttons. The running programme has
been cancelled.
If a new washing programme is to be selected, check that
there is detergent in the detergent dispenser.
"Half load" button
This option is useful and economical when only a small load
needs washing reducing the consumption of water and en-
ergy.
This option must be linked to the selection of a washing
programme. (Programmes with this option are indicated in
the chapter "Selecting the dishwasher cycle").
When selected, a back light will illuminate "Half load".
Load the dishes into both baskets (upper basket and lower
basket).
When using this option we recommend to reduce the dose
of detergent that is normally used for a complete load.
Setting the delay timer
3
With the delay timer you can delay the start of a
dishwashing cycle for between 1 and 19 hours.
1. Press the delay timer button repeatedly until the multi-
display shows the desired time delay, for example 12h, if
the cycle is to start in 12 hours. The delay timer indicator
is illuminated.
2. Select dishwashing cycle.
3. The time remaining to the start of the cycle is continu-
ously displayed (e. g. 12h, 11h, 10h, … 1h etc.).
Cancelling a delay start
To cancel a delay start in progress you have to reset the
dishwasher; follow the same instructions given in "Cancel a
washing programme in progress". Cancelling a delay start in-
volves also the cancelling of the washing programme set.
In this case you have to set the washing programme again.
To change the time delay:
As long as the cycle has not yet started, you can still change
the setting by pressing the DELAY TIMER button.
Cancelling the time delay:
Press the Delay Timer button repeatedly until the length of
the selected cycle appears in the multi-display. The selected
dishwashing cycle will begin immediately.
To change a dishwashing cycle
As long as the cycle has not yet started, you can still change
the dishwashing cycle. First cancel the dishwashing cycle,
then reset the time delay, lastly select the new dishwashing
cycle.
Switching off the dishwasher
Only switch the dishwasher off when the multi-display indi-
cates “0” for the cycle time remaining and the end of pro-
gramme indicator is illuminated.
With some dishwashing cycles, the drying fan continues to
run even after the end of the cycle.
1. Press the ON/OFF button. All display indicators will go
out.
2. Turn off the water tap.