John Lewis JLDWW 1203 - Manual (Page 15)

15
Rinse Aid
Rinse aid is automatically added during the last rinse.
Rinse aid will ensure the water flows away easily from the
crockery, ensuring thorough rinsing, spot and streak free,
leaving gleaming dishes and glassware.
The dispenser which is positioned inside the door, holds
about 140ml of Rinse aid which is sufficient for 20 to 40
Dishwashing programmes, depending on the dosage setting.
If you do not use 3in1 detergent, fill up with rinse aid:
– Before using the dishwasher for the first time.
– When the control indicator for rinse aid is illuminated on
the control panel.
Use only special rinse aid for dishwashers.
Filling with rinse aid
1. Open the container by pressing the release button (A).
2. Add the rinse aid until the container is completely full.
The maximum level for filling is indicated by "max".
Ensure that the lid is closed after every refill.
Clean up any rinse aid spilt during filling with an ab-
sorbent cloth to avoid excess foaming during the
next wash.
Only use branded rinse aid for dishwashers. Never
fill the rinse aid dispenser with any other substances
(e.g. dishwasher cleaning agent, liquid deter-
gent).This would damage the appliance.
Adjusting the dose
According to the finish and drying results obtained, adjust
the dose of rinse aid by means of the 6 position selector
(position 1 minimum dosage, position 6 maximum dosage).
The dose is factory set in position 4.
Increase the dose if there are drops of water or lime spots
on the dishes after washing.
Reduce it if there are sticky whitish streaks on the dishes or
a bluish film on glassware or knife blades.
Top up the rinse aid when the indicator light on the
control panel illuminates.