JVC CA-MXDK11 - Manual (Page 9)

6
¤ Voltage Selector
Use a screwdriver to rotate the voltage selector so that the
voltage mark is pointing to the same voltage as where you
are plugging in the unit. (See also the back cover page.)
Preparing the Remote Control
When using the remote control
Point the top of the remote control toward the remote sensor
as directly as possible. If you operate it from a diagonal
position, the operating range (approx. 5 m) may be shorter.
If the range or effectiveness of the remote control decreases,
replace both batteries.
Changing the Color System
You can select the video output to match the color system of
your TV (PAL or NTSC).
1
Enter the color system setting mode.
2
Select the color system.
3
Store the setting.
Canceling the Demonstration
When you plug in the AC power cord to a wall outlet, the
System automatically starts the display demonstration.
To start the demonstration, select DEMO START.
DO NOT plug in before setting the voltage
selector on the rear of the unit and all
connection procedures are complete.
Voltage mark
When your mains lead (AC)
line voltage is 220 V When your mains lead (AC)
line voltage is 230-240 V
Voltage mark Voltage mark
When your mains lead (AC)
line voltage is 127 V When your mains lead (AC)
line voltage is 110 V
Voltage mark
Caution
Do not expose batteries to heat or flame.
(While holding...)
2 sec.
MX_DK11.book Page 6 Wednesday, December 13, 2006 5:11 PM