JVC CA-MXDK11 - Manual (Page 11)

8
Daily Operations
—Playback
¥ Turn on the power.
The STANDBY lamp on the main unit goes off.
• Without pressing
AUDIO, the System also turns
on by pressing one of the source selecting buttons in
the next step.
ø Select the source.
Playback automatically starts if the selected source is
ready to start playback.
• If you press AUX, start playback on the external
component.
Adjust the volume.
[ Operate the target source as explained
later.
To turn off (standby) the System
Adjusting the Volume
The volume level can be adjusted in 32 steps (VOLUME
MIN, VOLUME 1 – VOLUME 30, and VOLUME MAX).
Continued on the next page...
In this manual, the operations using the remote control
are mainly explained; however, you can use the buttons
and controls on the main unit if they have the same (or
similar) name and marks.
Number
buttons
The STANDBY lamp on the main unit
lights in red.
• A small amount of power is always
consumed even while on standby.
For private listening
Connect a pair of headphones to the PHONES jack on the
main unit. The sound will no longer come out of the
speakers. Be sure to turn down the volume before
connecting or putting on the headphones.
• Disconnecting the headphones will activate the
speakers again.
DO NOT turn off (standby) the System with
the volume set to an extremely high level;
otherwise, the sudden blast of sound can
damage your hearing, speakers and/or
headphones when you turn on the System or
start playback.
Remote control: Main unit:
MX_DK11.book Page 8 Wednesday, December 13, 2006 5:11 PM