Jacuzzi Finestra FL61000 - Manual (Page 18)

Jacuzzi Whirlpool Bath: finestra Walk-in Bath Page 1 fl61000B • 10/07
Pro 3 ozone sanitation system
The unit has a PrO 3 Ozone Sanitation System installed. The
ozone generator is set to operate as follows.
At the time the power is initiated, the ozone operates for thirty
minutes, and then it will automatically shut off. Thereafter,
every four hours, the ozone will operate for thirty minutes
automatically and continuously.
note: A soft noise is produced by the pump during operation
of the equipment.
to set timer
Determine the best time for the ozone generator to operate.
The ozone generator should be programmed to operate when
the air bath is not in use. Six hours before use, interrupt the
power to the air bath at the dedicated GFCI circuit breaker. Be
sure to observe all safety precautions. When the dedicated
GFCI circuit comes back on, the system is activated and the
ozone timer is set to begin a regular cycle as scheduled.
CaUtion: In the event of a power outage, the timer period will
need to be reset.