beautypg.com

Connections – JVC SP-PWC3 User Manual

Page 11

background image

Connections

8

CAUTION
• When you connect speakers other than the supplied ones, use

speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.

• DO NOT connect more than one speaker to one speaker terminal.
• Be sure to have them installed on the wall by a qualified

personnel.

• DO NOT install the satellite speakers on the wall by yourself to

avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.

Care must be taken in selecting a location for speaker installation
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.

Precautions for daily use
• When moving the speakers, do not pull the speaker cords;

otherwise, the speakers may fall over, causing damage or injury.

• When holding a speaker, always grasp the lower portion.
• Do not lean against the speakers, as the speakers could fall down

or break, possibly causing an injury. Especially be careful that
children do not lean against them.

Connecting the satellite
(front, center, surround)
speakers

4

16

FROM
XV-THC3
XV-THS55
XV-THS58
XV-THS66

• Connect the black cords to the black (r) terminals.
• Connect the white cords to the (q) terminals

referring to the table below:

Speaker cord

FRONT SPEAKERS (LEFT)

White

FRONT SPEAKERS (RIGHT)

Red

CENTER SPEAKER

Green

SURROUND SPEAKERS (LEFT)

Blue

SURROUND SPEAKERS (RIGHT)

Gray

Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.

Powered subwoofer

SP-PWC3

Front speakers

SP-THC3F

Surround speakers

SP-THC3S

Center speaker

SP-THC3C

Do not connect the power cord until all other connections have been made.

TH-C3[B]_new.book Page 8 Thursday, May 19, 2005 1:52 PM

This manual is related to the following products: