JVC HM-DR10000EU - Manual (Page 8)

8
EN
INITIAL SETTINGS (cont.)
Preset
Download
When you connect the recorder and your TV via fully-wired
21-pin SCART cable (
੬
pg. 4), you can set the recorder's tuner
channels by downloading preset data from your TV instead of
using the Auto Set Up function (
੬
pg. 6). After downloading is
completed, the recorder sets the clock and Guide Program
number automatically. For details, refer to the instruction
manual for your TV.
PERFORM PRESET DOWNLOAD
1
Press OK.
If you are referring to the front display panel
Press
%fi to select "CH – –" and press OK or #
.
If you are referring to the on-screen display
Press %fi to move the
highlight bar (pointer) to
"T-V LINK" and press OK
or
#
.
Preset position on the display panel increases from
"CH1"; do NOT press any button on the recorder or
remote control until the display panel shows clock
time, "(CH) 1" or "– –:– –" as illustrated on page 9.
● If you are using the on-
screen display, the T-V
LINK screen will appear.
Then the GUIDE PROG
SET screen will appear
during Guide Program
number set.
● If you press any button
on the recorder or
remote control while
downloading is in
progress, it will be
interrupted.
NOTES:
● In the area where no TV station transmits a PDC signal, the
recorder can perform neither auto clock set nor auto Guide
Program number set.
● If there is a power cut, or if you press or MENU while
downloading or set up is in progress, it will be interrupted; be
sure to turn off the recorder power once and try again from the
beginning.
● Auto clock may not function properly depending on the
reception condition.
● When you perform T-V LINK function, be sure to use fully-
wired 21-pin SCART cable.
● On this recorder, the characters available for station’s name
(ID) are A–Z, 0–9, –,
* , + and (space). Some downloaded
station’s name may differ from those of your TV ( ੬ pg. 66).
Perform steps 1 to 3 of "Auto Set Up" on page 6 and 7 before
continuing.
You can use this function only with the TV offering
T-V Link, etc.*
* Compatible with TVs offering T-V Link, EasyLink, Megalogic,
SMARTLINK, Q-Link, DATA LOGIC or NEXTVIEWLINK via fully-
wired 21-pin SCART cable. The degree of compatibility and
available functions may differ by system.
T-V LINK
PLEASE WAIT
[MENU] : EXIT
GUIDE PROG SET
PLEASE WAIT
[MENU] : EXIT
AUTO SET
T-V LINK
[ 5∞] =
[MENU] : EXIT
1 2 3
4 5 6
7 8 9
1
2
1
2
3
– –:– –
0
3
4
4
OK
MENU