JVC CA-TD77R - Manual (Page 48)

44
English
6. Press the SET button.
Proceed to step 6 .
To use a Cassette Deck as the source
1. Press the left or right cursor key (
4 or ¢)
until “TAPE” blinks on the display.
2. Press the SET button.
Proceed to step 6 .
To Use the current source as the playback source:
1. Press the left or right cursor key (
4 or ¢)
until “– – – –” blinks on the display.
2. Press the SET button.
Proceed to step 6 .
6. Setting the volume level.
Press the left or right cursor key ( 4 or ¢) to adjust
the volume level.
VOLUME - A: Sets the volume level to 5.
VOLUME - B: Sets the volume level to 12.
VOLUME - C: Sets the volume level to 20.
VOLUME - - : Sets the volume to the last volume setting used.
7. Press the ENTER button.
The “DAILY” indicator changes from a blinking display to a steady display. The ON TIME, OFF
TIME, PLAYBACK SOURCE (including the disc number and track number if a CD source is
selected) are displayed then the display reverts to the previous display, before the Timer was set.
Turn the power off if you made the timer settings with the power turned on.
o If you make a mistake while setting the Timer, press the CANCEL button to return to the previous
setting. You can use the CANCEL button to return to the On Time setting.
o A few seconds before the start time for the timer, the System automatically turns on the power and
displays “DAILY” and “TIMER” alternately on the display. When the set time is reached, playback
starts using the selected source. A few seconds before the end time for the timer. “TIMER” blinks on
the display and when the end time is reached the power is automatically turned off again.
o If you change the source while the DAILY timer is running, the timer operation is cancelled.
Before Turning Off the Unit
o If the source is a CD, make sure that there is a CD in the selected disc number.
o If the source is a tape:
•
Make sure that there is a tape in the Tape Tray.
• Check that the tape direction is correct. This is important especially when Reverse Mode is off.
• Set Reverse Mode on if you want to play both sides of the tape.
o Select the Sound Mode if you want to listen using a Sound Mode effect.
To change the DAILY Timer setting
To change the settings for the DAILY Timer, repeat the setting procedure from the beginning.
Turning the DAILY Timer On and Off ———————————
Once the DAILY Timer has been set, it will be activated at the same time every day until the setting is
turned off.
To Turn the DAILY Timer Off
1. Press the MENU button.
“DAILY” appears on the display and the DAILY indicator in the “TIMER” section of the menu
display blinks.
2. Press the CANCEL button.
“DAILY OFF” appears on the display and the DAILY indicator in the TIMER section of the menus
goes out.
TIMER
DAILY
TIMER
DAILY
TIMER
DAILY
ENTER
ENTER
CANCEL
1
2
7
6
CA-TD77R[EF]/EN/p26-52 97.7.24, 2:45 PM 44