JVC CA-TD77R - Manual (Page 29)

25
English
2. Preset stations are being searched for and while
preparing to change the station, sound will be muted.
3. The station will be changed and the programme type
being received will appear on the display.
• When using the DISPLAY MODE button to change the display, use the appropriate setting for the
type of display.
Notes:
• EON broadcasts of some stations may not be compatible with this Unit. In the case of an incompatible
EON broadcast, “EON” will not appear on the display.
• While the Unit is receiving information for an EON code you have selected for EON Standby, you
cannot use the following operations: cursor key, TA/NEWS/INFO button or PTY SEARCH button. In
addition, if a station transmits information for a programme type you have selected without sending
the EON code, the EON Standby operation is still performed. Therefore, you will not be able to use
the operations listed above during this period.
• If the reception is unsatisfactory for a station among the preset stations, “WAITING” appears on the
display and the station is searched for again. If after searching through the channels five times, the
broadcasting station cannot be found, “NOT” and “FOUND” are displayed alternately on the display.
The Unit will then return to the station to which it was previously tuned.
When broadcasting of the desired information has been completed, “EON END” will be indicated and the
Unit will automatically go back to the station which had previously been tuned to.
o While receiving information on EON Standby reception, the station will not change to other stations
even if the same information is available from them.
o If you cancel the EON function when in EON Standby reception mode by either pressing the EON
ON/OFF button, the Unit will automatically return to the station which had been previously tuned-in.
If the information you are waiting for is available from the current station, the indicator will blink.
ALARM function ——————————————————————
If an ALARM (Emergency) signal is received while receiving an EON code from a station, “ALARM”
blinks on the display and the Unit automatically switches to the station broadcasting the ALARM signal.
When an ALARM broadcast of PTY is being received from the currently tuned-in station, “ALARM” will
blink on the display for your attention.
TAPE
TUNED STEREO
AUTO
[ TA NEWS INFO ]
1 2 3 4
5 6 7 8
9 10 11 12
14 13 15 16
CH
Blinking
TAPE
TUNED STEREO
AUTO
[ TA NEWS INFO ]
1 2 3 4
5 6 7 8
9 10 11 12
14 13 15 16
CH
Blinking
CA-TD77R[EF]/EN/p1-25 97.7.24, 3:18 PM 25