Jacuzzi J - 400 SERIES J - 460 - Manual (Page 76)

Page 71
J-400 Series
20.12 wireless remote Battery replacement Procedure
1. Start by removing the rubber cover to the
remote (Figure A).
2. Turn the remote unit over and locate the battery
door (Figure B).
3. Rotate the battery door, with a coin, counterclockwise until
the dot aligns with the Open arrow (Figure C).
4. Remove battery door using coin to pry the door upward
(Figure D).
5. Replace battery using CR2025 or equivalent
(Figure E).
6. Reinstall the battery cover, using the coin to close
(Figure F).
7. Reinstall rubber housing onto remote (Figure G).
note: Remote unit is water resistant not waterproof, therefore
the unit should never be left in the spa while the cover is on
and spa is not in use.
Fig. A
OPEN CLOSED
Battery
Door
Fig. B
OPEN CLOSED
Fig. C
OPEN CLOSED
Fig. D
OPEN CLOSED
CR2025
Fig. E
OPEN CLOSED
Fig. F
Fig. G