beautypg.com

Jacuzzi J - 400 SERIES J - 460 User Manual

Page 21

background image

Page 16

J-400 Series

!

warnInG:

TO DeCrease rIsK OF InFeCTIOn Or

DIsease.

Fill hot tub with clean tap water from garden hose, to reduce risk of

contracting a waterborne illness (e.g. an infection, bacteria or virus)

and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)

ImPOrTanT: Always fill your spa through both filter buckets after

draining. Failure to do so may cause air to be trapped in either

pump, preventing the pump from circulating water. Remove the

hose and replace both filter cartridges as illustrated in section 13.1

(page 43).

3. Turn On Power

Turn on power to spa at the home’s circuit breaker. The heater and
filter/circulation pump will automatically activate. If the control panel
LCD flashes water temperature and “COOL” or “ICE”, this is normal.
Refer to pages 51-52 for additional information.

4. activate Jets Pumps

Turn on all jets(s) pumps when adding chemicals in step 5.

5. add start-up Chemicals

Add the spa water chemicals as recommended by your
authorized Jacuzzi spa dealer. See section titled “Water
Quality Maintenance” (page 49) for general guidance.

warnInG:

rIsK OF POIsOnInG Or DeaTH.

Never leave chemicals opened and accessible to anyone. Use
chemicals according to the vendors instructions. Always store
chemicals in a safe and/or locked location. Keep away from
and out of reach of children.

!

6. establish a stable sanitizer reading

Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine
or 2.0-4.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals/USA printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the Decontamination Procedures on the following page.

note: The “Decontamination Procedure” should also be used after
the spa has been “Winterized” (sec. 13.7, page 47) or has been sitting
without power for an extended period.

This manual is related to the following products: